enigma smart hardwire kit for nextbase dashcams [optional] A16X

Product Specification & Installation Guide

Input: 12V/24V Output 5V2A max Length 4M

Ground

Battery Low Voltage Protection Setting Vja switch on/off of the smart hardwire kit, it helps to

set up the vehicle battery over-discharge protection. It is suitable for any type of vehicles runs 12/24V This smart hardwire kit provides 4 setting options of voltage cut off value detail corresponding protection voltage as follows:

12V 11.8V 12.0V 12.2V 12.4V

24V 23.6V 24.0V 24.4V 24.8V

Smart hardwire kits has overload protection and the protection current within 2.5A

● Smart hardwire kit is working while the vehicle on: after the vehicle of it will operate normally until the vehicle's battery drops below the minimum voltage cut-off level, it will automatically stop to supply power to protect the vehicle's battery after 100 seconds +/- 15 seconds

While ACC is activated, smart hardwire kit can operate continuously.

Precautions

O Please select an appropriate voltage setting, and then preform wiring after power-on test is normal..

If vehicle's ignition is turned off, dash cam cannot operation in normal, please check the vehicle's

battery voltage and recharge it The low voltage protection function will have tolerance value, it will not affect the detection of

vehicle's battery voltage.

While wiring, please avoid hindering the normal use of the original vehicle equipment.

Professional installation is recommended.

The smart hardwire kit can be used for all NEXTBASE

Asia edition dash cams